Sta-Lok Stemball

£69.00£141.00

  • Sta-Lok Self-Fit Terminal, the reusable alternative to swage
  • Only basic hand tools required
  • No pre-measurement needed
  • Quick and easy to install
  • Guaranteed stronger than wire rope
  • For right hand and left hand lay wire rope
  • Packed for 1×19 wire as standard
  • Manufactured from high specification 316 stainless steel
  • Different wedges are available to terminate 7 strand & compacted strand wire ropes
  • Two part assembly – Threadlock recommended
  • Can be used with Stemball Cup to bring head size up to fit mast / spreader brackets

Description

Over 48 years since its inception, Sta-Lok self-fit terminals are used around the world and have gained worldwide recognition for high quality and reliability.

For use with the right hand and left hand lay 1×19, 7×19, 7×7 and compacted strand stainless steel wire rope from 3mm – 26mm (1/8” – 1”).

The Sta-Lok self-fit terminal will work under constant loading and variable shock loading. The termination is stronger than the rated breaking load of the wire rope. In all situations, the Sta-Lok terminal has proven to be totally reliable and re-usable*.

*Just a new wedge is required

  • Assemble on-site, easy to install with simple hand tools
  • No pre-measurement required
  • A different wedge is required for 1×19, 7 strands and compacted strand wire rope
  • All our wedges are laser marked for easy identification and selection
  • Guaranteed stronger than wire rope

Sta-Lok Wire Connector Terminals – Technical Information – How to assemble
Sta-Lok Terminal Instruction 11. Cut wire rope and slide socket component over wire.

Wind tape around wire approx 12″ (300mm) from end. This will prevent the socket from sliding down the wire.

TIP: If using a hacksaw to cut your wire rope, wind tape around wire to ensure a neat cut.


Sta-Lok Terminal Instruction 2

2. Unravel outer strands 2″ to 3″ (50-76mm) to expose central core.

TIP: Use a screwdriver to prise initial strands out of position.


Sta-Lok Terminal Instruction 3

3. Slide wedge component over central core of wire rope.


Sta-Lok Terminal Instruction 4

4. Reposition outer strands.

Turn outer strands either clockwise or anti-clockwise, depending on the lay of the wire, around the wedge. Ensure approx 1/8″ (2-3mm) of the central core protrudes from the end of the wedge.

Outer strands should be evenly situated around the wedge. Care should be taken to ensure that a strand does not slip into the slit of the wedge.

TIP: Push the socket towards end of wire, while repositioning the outer strands, this will help control. When wire strands are in position, push socket firmly, as indicated to hold wires in position.


Sta-Lok Terminal Instruction 5

5. Final assembly.

Ensure former component sits in bottom of end fitting. Screw socket assembly into end fitting and tighten with spanners. The assembly is now complete.

TIP: Undue force is not required to terminate the wire.

Fitting instructions are supplied with each Terminal.

Additional information

Size

6mm, 7mm, 8mm, 10mm